1-17
GENERAL MAINTENANCE
DANGER
DANGER
TAILGATE SAFETY PROP
INSTALLATION PROCEDURE
1.
Make sure there is no garbage
inside the body.
2.
Remove both the tailgate safety
pins.
3.
Start the engine.
4.
Turn the PTO switch ON and open
the tailgate about 3 feet high.
5.
Remove the safety prop lock pin
and raise the prop in a position
where both locking holes are
aligned together (Figure #1.7).
6.
Insert the lock pin to maintain the
safety prop in place.
7.
Lower the tailgate so it rests on
the safety prop.
FIGURE #1.7
1.7
TAILGATE SAFETY PROP
The tailgate safety prop is used to support
and keep the tailgate open during inspection
or when maintenance is carried out on the
vehicle. It is mandatory to install the safety
prop each time the tailgate is open for such
purpose.
The safety prop can be easily installed
when the tailgate is slightly open. Apply the
following procedure to install the safety
prop.
ALWAYS USE THE TAILGATE
SAFETY PROP WHEN WORKING
UNDER A RAISED TAILGATE. THE
SAFETY PROP MUST BE
INSTALLED EVEN IF THE
TAILGATE IS IN THE FULLY
RAISED POSITION.
ENSURE THAT NO ONE IS
STANDING BEHIND THE TRUCK
AND THERE IS NO WASTE
MATERIAL IN THE BODY.
SAFETY PROP
SAFETY PINS
Summary of Contents for Automizer Versa Hand
