1-21
GENERAL MAINTENANCE
HOPPER CLEANING
PROCEDURE
1.
Park the vehicle in a proper place,
where the vehicle can be cleaned
out. Make sure to park the vehicle
on a safe and level ground.
2.
Ensure that the parking brake is
applied and the vehicle is tagged
out for maintenance purposes
(refer to the
section 1.5
“Lockout/
Tagout procedure”).
3.
Start the engine and engage the
hydraulic pump (PTO ON).
4.
Extend the arm, fully extend the
packer (Figure #1.12) and push on
the red button (Figure #1.13) to
stop the packer in this position.
The hopper door MUST be closed
in order to move the packer.
5.
Turn off the hydraulic pump and
the engine.
DANGER
1.11
CLEANING THE HOPPER AREA
The area behind the packer should be
cleaned out every day. The packer will not
work properly if waste accumulates in this
area; it could even cause severe damage
to the packer and other related parts.
This section indicates the cleaning
procedure of the hopper section.
APPLY THE “LOCKOUT/TAGOUT”
PROCEDURE TO PREVENT ANY
ENGINE START-UP.
Continued on next page. . .
FIGURE #1.12
FIGURE #1.13
EMERGENCY
STOP BUTTON
Summary of Contents for Automizer Versa Hand
