1-29
GENERAL MAINTENANCE
1”
FIGURE #1.28
PACKER LIMIT SWITCH
ADJUSTMENT PROCEDURE
7.
To adjust the ”packer retract” limit
switch, retract the packer to 1”
before the fully retracted
position (Figure #1.28), using the
yellow button on the packer
control station.
8.
Push the red button when the
packer reaches the right position.
PACKER LIMIT SWITCH
ADJUSTMENT PROCEDURE
9.
Locate the limit switch on the right-
hand side of the vehicle
(Figure #1.29).
10. Adjust the limit switch lever so it is
“active” when cylinder finger is in
the position shown on figure #1.29
(Limit switch is “clicked”). The
lever may require to be bent or
twisted to properly activate the
limit switch at this exact position.
11. Test the packer for a full cycle.
Make sure that there is no knocking
noise at both ends of the packer
cylinder stroke.
FIGURE #1.29
PACKER “RETRACT”
LIMIT SWITCH
CYLINDER
FINGER
1.12.2
LIMIT SWITCH ADJUSTMENT (Cont’d)
NOTE: If the vehicle is equipped with
proximity switches, loosen the proximity
switch on the bracket and move it over the
trigger lever to get the yellow light found on
the proximity switch to turn ON (Figure
#1.24A). The green light on the proximity
switch must be ON too.The gap between
the proximity switchand the trigger lever
must beadjusted to 3/16 of an inch.
Summary of Contents for Automizer Versa Hand
