AUTOMIZER
VERSA HAND
TM
1-34
WEAR PAD
REPLACEMENT PROCEDURE
1.
Ensure that the parking brake is
applied and the vehicle is tagged
out for maintenance purposes
(refer to the
section 1.5
“Lockout/
Tagout procedure”).
2.
Start the engine and engage the
hydraulic pump.
3.
Then using the joystick, extend
the automated arm to give a better
access to the hopper area.
4.
If the packer is not fully retracted,
press the yellow button on the
packer control station to retract it.
5.
Turn the hydraulic and the engine
off.
6.
Remove the hopper side panel
(Figure #1.39).
7.
Remove both side rail shields.
8.
Remove the lower bolts (4) of left
side wall to be able to remove the
left side rail (Figure #1.42-43).
1.12.5
WEAR PAD REPLACEMENT
Replacement of the wear pads at the top of
the packer (Figure #1.38) is required when
vertical movement of the packer is greater
than 3/16” (Check with a pry bar).
This section will provide the full procedure
to remove and change both wear pads at
the top of the packer.
FIGURE #1.38
PACKER
WEAR PAD
Apply the following procedure to remove
and change the wear pads.
DANGER
DO NOT CLIMB INTO THE
HOPPER WHILE THE PACKER IS
MOVING.
DANGER
SECURE THE AREA AROUND THE
PATH OF THE ARM WHEN
PERFORMING MAINTENANCE OR
REPAIR.
Summary of Contents for Automizer Versa Hand
