1-37
GENERAL MAINTENANCE
WEAR PAD
REPLACEMENT PROCEDURE
11. When both side rails are removed,
start the engine and engage the
hydraulic pump.
12. Extend the packer about 12 inches
before the end of the stroke
(Figure #1.47).
13. Turn the hydraulic pump and the
engine off.
12”
FIGURE #1.47
NOTE:
In order to move the packer (retract or
extend) for a short distance, press on the
green (or yellow) button then immediately
push the red button to stop the packer. Pull
the red button and repeat the process until
the packer reaches the desired position.
WEAR PAD
REPLACEMENT PROCEDURE
14. Remove and replace both wear
pads (Figure #1.45) and retract the
packer.
15. Reinstall the side rails.
16. Stitch weld the rails along the top
edge of the hopper wall
(Figure #1.44).
17. Reinstall the side rail shields.
18. Reinstall the hopper side wall
19. Reinstall the deflector cover back
in place.
FIGURE #1.48
PACKER
WEAR SHOE
DANGER
DO NOT CLIMB INTO THE
HOPPER WHILE THE PACKER IS
MOVING.
DANGER
SECURE THE AREA AROUND THE
PATH OF THE ARM WHEN
PERFORMING MAINTENANCE OR
REPAIR.
1.12.5
WEAR PAD REPLACEMENT (cont’d)
12”
Summary of Contents for Automizer Versa Hand
