AUTOMIZER
VERSA HAND
TM
1-68
STRAINER CLEANING
PROCEDURE
9.
Remove the hose clamp from the
suction hose (Figure #1.88) and
slide the hose over the pipe until it
clears the ball valve (slide towards
the frame of the vehicle).
10. Remove the strainer from the tank
port (Figure #1.89 and 1.89A).
11. Once the strainer is removed,
clean it using solvent, and inspect
for damage; replace if necessary.
12. Replace the seal if necessary and
re-install the strainer.
13. Refer to the hydraulic fluid
replacement procedure for filling
up the tank and ensure there is no
leak.
1.14.8
STRAINER CLEANING PROCEDURE
(Cont’d)
FIGURE #1.88 (Cylindrical tank)
HOSE CLAMP
Strainer / ball valve
assembly
FIGURE #1.89
Seal
Strainer
*Cylindrical tank shown
Bolts
(4)
Summary of Contents for Automizer Versa Hand
