AUTOMIZER
VERSA HAND
TM
1-86
FIGURE #1.115
BODY HOIST REPLACEMENT
PROCEDURE
8.
Disconnect the hydraulic hose and
fitting (Figure #1.114).
9.
Remove the cylinder base pillow
blocks (Figure #1.115).
10. Replace the cylinder.
11. Reinstall the cylinder base pillow
blocks on both sides and
reconnect the hydraulic hose.
12. Start the engine and engage the
hydraulic pump.
13. Slowly raise the cylinder until it
reaches the top of the cover where
the lock nut will be tightened. Note
that the cover must be aligned
with the threaded rod at the top
end of the cylinder.
14. When the threaded rod passes
through the cover, install the
locknut.
15. Lubricate the cover and the base
pillow blocks (Figure #1.115 & # 1.116).
16. Lift the body, store the safety prop
and check for proper operation.
BASE PIILLOW
BLOCKS
FIGURE #1.116
FIGURE #1.114
HYDRAULIC
FITTING
COVER
PILLOW
BLOCKS
1.16.2
BODY HOIST REPLACEMENT (cont’d)
Summary of Contents for Automizer Versa Hand
