1-95
GENERAL MAINTENANCE
1.17.5 GRAB PACK
The Grab Pack switch (see Figure #3.33 of
Operator Manual) enables the packer to
automatically start cycling about 4 seconds
after the grabber is closed. This will give
the arm enough time to reach the hopper
and dump the cart before the packer starts
to pack.
With a multi-cycle system, if the packer is
set to perform 3 cycles (set in factory to
3 cycles, adjustable from 2 to 8; see
section 3.2.5 Multi-Cycle Control of
Operator Manual), the packer will complete
all its cycles until the next time the operator
closes the grabber. When theoperator
closes the grabber, the multi-cycle function
is reset.
IIf the grabber is closed in the middle of a
cycle, the packer will interrupt its current
cycle, return to its fully retracted position,
and then restart the next cycle. When a
cycle is interrupted and the packer has
returned, there is no delay before the
packer restarts the next cycle. The four-
second reset will apply only when the
packer has completed all its cycles (2 to 8)
and when it has returned to its fully retracted
position.
Interrupting a cycle prevents dumping carts
directly over the packer. Piled material
over the packer could reduce it’s efficiency.
Summary of Contents for Automizer Versa Hand
