1-97
GENERAL MAINTENANCE
GRABBER CHAINS ADJUSTMENT
PROCEDURE
1.
Fully open the grabber.
2.
Make sure that the grabber
cylinders are completely
retracted.
3.
Unscrew the nuts of the adjustment
screws on both sides of the
grabber.
4.
Adjust the chains until the grabber
is symmetrical. To loosen a chain,
screw the inner nut and unscrew
the outer one. To tighten up a chain,
screw the outer nut and unscrew
the inner one. Don’t tighten up the
chains too much.
It may be also necessary to adjust the
grabber chains when the grabber is not
centered with the arm.
INNER NUT
ADJUSTMENT
SCREW
OUTER NUT
5.
Close the grabber completely and
make sure that the cylinders are
fully deployed. The chains MUST
not be too tight. If so, loosen the
chains as decribed at the step 4.
NOTE: Make sure that the adjustment
screw doesn’t turn to avoid
twisting the chains.
RIGHT-HAND SIDE
OF THE GRABBER
LEFT-HAND SIDE OF
THE GRABBER
Summary of Contents for Automizer Versa Hand
