42
Controls and Indicators
Figure 3-8 Crusher panel
The crusher panel can be lowered upon refuse to prevent refuse from popping up in front of the
packing ram, increasing the compaction at any time and also during the load-breaking sequence.
To help during the unloading sequence, you should leave a good amount of garbage in front of the
packer and under the lowered crusher panel as you finish your route. Once you are at the landfill and
the body is raised, you can activate the packing ram to help clear whatever could be jammed in the
hopper. This procedure can also be done without the crusher panel.
Auto-Packing Control Switch (optional)
The
AUTO
-
PACKING
control switch (see Figure 3-9) enables the packer to automatically start cycling
about 4
seconds after the grabber is closed. This gives the arm enough time to reach the hopper and
dump the cart before the packer starts to pack.
If the unit is equipped with the multi-cycle function (refer to “Multi-Cycle Control Switch” on
page 46), the packer will complete the preset number of cycles until the operator closes the grabber.
When he does, the multi-cycle function is reset.
If the grabber is being closed in the middle of a cycle, the packer interrupts the current cycle, returns
to its fully retracted position, and then restarts the next cycle. When a cycle is interrupted and the
packer has returned to the home position, there is no delay before the packer restarts the next cycle.
The four-second reset applies only when the packer has completed all its cycles (2 to 8) and when it
has returned to the home position.
Interrupting a cycle prevents dumping carts directly over the packer. Piled material over the packer
could damage the follower panels.
Summary of Contents for Automizer Versa Hand
