Operating the A
UTOMIZER
V
ERSA
H
AND
TM
67
Figure 4-5 Safety pin
5.
Fully open the tailgate.
6.
Raise the body. Garbage should slide out.
7.
Slowly move the vehicle forward to prevent the garbage from piling up under the tailgate. This is
the only time you can move the truck with body raised. Do it very cautiously and cover the
shortest distance possible. Always be aware of the overhead clearance.
8.
Cycle the packer to help eject the garbage. It may be helpful to have some garbage left in the
hopper to enhance the effect of the packer cycle on the garbage.
9.
Lower the body and close the tailgate.
10.
Put safety pins back in place.
11.
Drive away from the unloading site.
12.
Perform end-of-the-day inspection (See
End-of-the-Day Cleaning and Inspection
.
Unloading Corrective Actions
As you unload the body, some garbage may fall or be blown away between the chassis and the body.
Apply the following procedure for the remaining garbage stuck on or between the chassis and the
body:
1.
Lift the body until the safety prop is clear to tilt under it.
2.
Release the safety prop by pulling the handle.
Warning!
Never
move the truck backwards with the body in raised position.
Never
raise the body if the tailgate is not fully open.
Danger!
Always use the tailgate safety prop while working under a raised tailgate. The safety prop
should be used even if the tailgate is in fully raised position.
Summary of Contents for Automizer Versa Hand
