6
C
HAPTER
1
Safety
Responsibilities of
the Employee
It is the responsibility of the
employee:
•
To enforce all safety measures to
meet the requirements established
by the employer.
•
To operate the Expert(t) 2000
TM
only
after having received instruction
and training.
•
To immediately report to the
employer or supervisor any
damage or malfunction of the
vehicle.
•
To make sure that nobody is near
the vehicle before activating any of
the controls and to be prepared to
stop at any indication of possible
danger.
Lockout/Tagout
The Lockout/Tagout procedure must
be applied to render the vehicle out of
service and thus ensure its safety, and
that of persons around it.
To lock out and tag out the Expert(t)
2000
TM
:
1.
Apply the parking brake.
Figure 2. Parking brake
2.
Turn off the engine.
3.
Remove the key from the ignition
switch.
4.
Place the key in a safe and
controlled area.
5.
Cover the ignition switch, with
tape.
Note:If the Expert(t) 2000
TM
is
equipped with a master switch
on the battery set, you must
turn it off.
6.
Put an “OFF SERVICE” tag on
the driver’s steering wheel.
7.
Put an “OFF SERVICE” sign on
the front windshield.
8.
Block, with an adequate,
easy-to-see safety prop, any
Summary of Contents for expert 2000
