U SER’S M AN UAL
Do not use a steam cleaner to clean the appliance.
Gas flame hob :
T
he burners are made in two parts in order to facilitate cleaning. Clean them separately,.
→ Burner cap :
B
urner caps are made of solid brass. Use a special brass-cleaning product (e.g. MIROR
®
) and a soft
cloth.
I
f the product runs onto the enamel do not rub (these products generally contain
abrasives). Rinse immediately with clean water without rubbing.
I
f the caps are very dirty polish them with very fine sand paper and then rub them with a copper
cleaner.
→ Burner body :
T
he aluminium bodies of the burners become stained with use. They should be cleaned regularly
with a scouring pad (Scotch Brite
®
) or washed in the dishwasher.
A
fter removing the pan supports and burners, the cooking surface can be cleaned easily and
thoroughly by simply using a sponge.
D
o not use scouring pads or abrasive products such as oven cleaners and stain removers.
When cleaning, be careful not to splash liquid into the openings of the burners.
Pastry tray :
B
aking sheets are made of blued steel. Unless they are protected with grease they rust very rapidly.
They should therefore be coated with a greasy film (butter, oil) after cleaning.
Body :
You can use special-purpose products for stainless steel (e.g. SUMAINOX ®, JOHNSON STAINLESS
STEEL ®, PPZ STAINLESS STEEL ®). Never use abrasive products.
Stainless-steel top :
T
he entire hob is dished or comprises dished recesses for easy cleaning and improved hygiene (no
water trap). The hob should be cleaned with liquid, non-chlorinated products to avoid scratching the
steel.
I
f the hob is stained use a clay stone- and soap-based paste available from department stores
.
Stainless-steel trim: :
T
he stainless-steel trim should be cleaned with aerosol products available from department stores.
You should nevertheless choose a cleaner that contains only a small quantity of silicone to avoid
leaving white streaks after the product dries.
Brass trim :
Use a special brass-cleaning product (e.g. MIROR®) and a soft cloth. If the product runs onto the
enamel do not rub (these products generally contain abrasives). Rinse immediately with clean
water without rubbing.
Another solution is to use solid soap (Pierre d’argent, Pierre d’argile) applied with a damp sponge
to the zones to be cleaned.
Before any cleaning work, close the gas supply and/or isolate from the
mains supply
CLEANING AND MAINTENANCE
Notice provisoire Beaune - Bussy UL - FT164h - Date : 16/10/12
41/42
