USER’S MANUAL
CLUNY
Page 33 of 42– US –
U
se:
Turn on main gas supply to range.
-
Depress handle & rotate burner valve handle anti-clockwise
past the “IGN” position.
-
Depress handle fully and wait for the burner’s thermocouple
to heat up. Hold for 15-20 seconds
after flame has lit
.
Igniters will spark (click) while handle is pressed.
-
Release handle and rotate burner valve handle to “HIGH”
position.
-
Depress & rotate burner valve handle to the “LOW”
position.
-
To rotate burner valve handle to the “OFF” postion, slightly
depress handle then move to the “OFF” position.
A reduced flow rate position identified by the “Low” mark
produces the preset minimum burner power. This setting is
adjustable behind the knob.
C
leaning the heating plate:
Immediately remove any spillages to make cleaning easier. You can use commercially available special products
for cleaning cast iron.
If the cast iron is heavily soiled, use scouring pads and grease after cleaning.
DO NOT USE WATER TO CLEAN THE HEATING
PLATE WHEN IT IS HOT.
This can damage it.
GAS OVEN
TOP BURNER
LOW
HIGH
OFF
IGN
250
300
350
400
HI
570
IGN
OFF
LO
