GAS
Pressure
Ø
Natural Gas
6" WC
0.90
1.30
1.45 1.70
L.P. propane
10" WC
0.65
0.90
1.05 1.20
Adjustment of reduced flowrate of surface burners (Figure 23):
After connection or change of gas, it is
crucial
to modify this
adjustment.
- Remove the control knob. Light the burner, adjust to
minimum setting, then use a small screwdriver to set the
adjusting screw
J
.
Note:
Flame is reduced to ¼ of its size in the minimum setting,
the burner must remain lit when changing from maximum
setting to minimum setting.
Refitting the cooking surface:
When refitting the cooking surface, it is vital to tighten
fastening screws (figures 13, 14 and 15). Failure to do so can
cause distortion of the cooking surface.
OVEN BURNERS:
Disassembling of the gas oven burner:
Withdraw the plate (Fig.24).
CAUTION:
when refitting place the base underneath the groove on the fascia (fig.25).
Unscrew screw K holding the burner (Fig.26).
Remove the drawer.
Loosen the set screw L (Fig.27).
Push the burner towards the back of the oven cavity and to raise it to release it.
Oven orifice:
Remove the base,
CAUTION:
when refitting place the base
underneath the groove on the fascia (Figures 24 and 25).
To remove the oven burner:
J
Fig. 23
Fig. 26
K
Fig. 25
Fig. 24
Fig. 27
L
Fig. 28
Page 13 of 38 – US –
Summary of Contents for Fourneau "Rully"
