INSTALLER’S MANUAL
INSTALLER’S MANUAL
5
ADJUSTMENT OF THE HOB BURNER
ADJUSTMENT OF THE HOB BURNER
OPERATION
:
1
Push down on the control knob and turn it anticlockwise; press simultaneously on the ignition
pushbutton.
Once the burner is lit, release the ignition pushbutton.
2
Still pushing down on the control knob, set it to the small flame «
»
setting.
After about ten seconds to allow for the engagement of the
thermocouple, release the control knob.
3
In the low flame setting, the flame must be low, steady and covering
slightly the tip of the thermocouple.
►If the flame goes off in the low flame setting, repeat the
procedure. If after several attempts you are unable to hold the
flame in the low flame setting, proceed to adjust the burner
(refer to Section “Adjustment of the hob burners”).
►If in the low flame setting, the flame is too strong, then the gas
delivery rate to the burner needs to be reduced.
Lacanche’s gas appliances are delivered fully adjusted in compliance with relevant regulations and
for use with the particular gas supply (type, pressure) stated in the purchase order and indicated in
the appliance’s nameplate.
Nevertheless, after connecting the appliance, the correct operation of the burners (hob and oven)
must be checked. If required, the height of the flame must be adjusted accordingly.
To do this, the gas delivery rate to the burner must be adjusted by screwing in or out the valve
adjustment screw located behind the control knob.
This adjustment is essential when changing the gas supply after having changed injectors (refer to
Section “Change of gas”).
WARNING:
The adjustment of burners must be carried out by a qualified technician.
ADJUSTMENT OF THE FLOW RATE
:
The adjustment of the low flame gas delivery rate is carried out with the
burner on and the control knob removed, using a small screwdriver to
screw in or out the screw in the gas valve located behind the control.
4
Replace the control knob and turn it to the large flame « » setting.
5
Turn quickly from the large flame « » setting to the small flame «
»
setting.
When doing this, the flame must remain burning.
At its minimum size, the flame must be a quarter (¼) in size of the full
flame.
When this is not the case:
Repeat the procedure from
1
to
5
.
1
With the burner on, set the control knob to the small flame «
»
setting.
3
Screw in or out the gas valve screw
to adjust the delivery rate for the low
flame. Screwing out increases the flame.
Screwing in reduces the flame.
2
Remove the control knob.
EN
10-2016
Multicooker
Chargrill
Electric fryer
Gas burners
Induction
Ceramic Hob
Plancha
Summary of Contents for LAG 020 R
Page 10: ......
