LACAVA LLC
4
Installation Instructions/Instrucciones de Instalación
1. Thread the locking nuts onto the catridge bodies
all the way down.
2. Insert the metal flat rings and rubber flat gaskets over
the catridge bodies, and then place the cartridge bodies
up through their designated holes from under the mounting
surface.
3. Then thread handles onto each extension from above
the mounting surface. Make sure the rubber O-ring is
placed between in the mounting surface and the handle
base in its groove at the bottom of each handle.
a) Align and hold the levers as desired in closed position;
b) Screw the base onto the cartridge stem until it locks
and lever can be turned to open/close the cartridge.
4. Thread each locking nut upwards as far as possible by hand.
a) Make final adjustments in the alignment the handle bases.
b) Tighten up both screws on the locking nuts to keep each
handle base securely in place by pressing the flat metal rings
against the mounting surface. Make sure not to overtighten,
as this can potentially cause damage to the mounting surface.
5. Remove the mounting hardware from the spout assembly
and insert the pop-up rod into the hole behind the spout.
1.
2.
3b.
4.
5.
3a.
4a.
4b.
