1. Unmount or safely remove the 4big Quadra volumes from your
computer, disconnect the interface cable and switch off the 4big.
2. To enter RAID modification mode, turn ON the 4big (do not select “AUTO”) and
simultaneously press the front LED button for 15 seconds. The front LED will
blink blue and red.
3. Push the + or - buttons on the RAID mode selector until the desired RAID
number appears.
4. Validate the mode by pushing the front
LED button. The 4big will start.
5. Turn off the 4big, allow it to shut
down and turn it back on.
6. Reformat the disks. Please refer to
the User Manual on the LaCie
Storage Utilities CD-ROM.
CAUTION!
- Changing the RAID mode will erase the data stored on the 4big quadra.
Back up data before changing the RAID mode.
- The 4 disk trays must be in place before the RAID mode can be modified.
NOTE:
See the User Manual for information on RAID modes.
Changing the RAID Mode
STEP 3
designed by neil poulton
designed by neil poulton
NOTE:
0=RAID 0, 1=RAID 10,
2=Concatenation, 3=RAID 3,
4=RAID 3+Spare, 5=RAID 5,
6=RAID 5+Spare, 7=N/A
.
