Setting Up Your LaCie Drive
12
LaCie Dupli Disc CD121
User’s Manual
3. Setting Up Your LaCie Dupli Disc CD121
3.1. Connecting The Power Supply
Warning!
Use only the AC adapter supplied with your LaCie drive. Using any other power cable may cause
damage to the device and void your warranty.
Important Note:
You may use your LaCie drive when in a foreign country, thanks to its autoswitching 100-240 Volt
power supply. To be able to use this feature, you may need to purchase an appropriate adapter. Consult LaCie
Technical Support for assistance in choosing the right adapter. LaCie accepts no responsibility for any damage to the
drive resulting from the use of an inappropriate adapter. Using an adapter other than one authorized by LaCie will
void your warranty.
Connecting The AC Adapter To The LaCie Dupli Disc CD121
1) Insert the round plug of the AC cable into the power input located at the rear of the drive.
2) Connect the wall-side plug to a power socket.
Disconnecting The AC Adapter From The LaCie Dupli Disc CD121
1) Turn the drive off and wait for it to spin down (+/- 10 sec.).
2) Hold the drive steady with one hand and gently remove the plug from the connector.
Warning!
Always remove the AC adapter before transporting your LaCie drive. Failure to remove the adapter may
result in damage to your drive and will void your warranty.
3.2. Stand-Alone Operation
Setting up your LaCie Dupli Disc CD121 for stand-alone duplication is a snap. Just follow the three basic steps below:
Step 1: Read the Safety Precautions section of this manual in order to use your LaCie Dupli Disc CD121 safely and correctly.
Step 2: Set up your LaCie Dupli Disc CD121 on a flat surface, in an appropriate place.
Step 3: Power on the LaCie Dupli Disc CD121 using the On/Off switch located on the back panel.
Your LaCie Dupli Disc CD121 is now up and running.
Power-Up Stage
When you turn on your LaCie Dupli Disc CD121, its DVD-ROM and CD-RW drives, electronic controller and memory are
initialized. The following section briefly describes this process.