6 OPERATION
42
TITAN VERSA Operations and Maintenance Manual
LACO Technologies
Operation
Refer to Factory Default Settings for information on initial settings. It is likely the
operator will change the default settings to support their unique application.
NOTICE:
Risk of seizing
Never move the detector while the unit is powered on, even if it is placed on a
moveable cart.
NOTICE:
Filling with oil
For VERSA models using wet pumps, oil level must be between min and max
level prior to being switched on.
NOTICE:
Connecting the primary pump
For VERSA C models, the external primary pump must be connected and
powered up before the detector is switched on.
Each time before powering on the TITAN VERSA:
1.
Become familiar with the safety instructions (see
.
3.
Check that all the connections are correct (see Installation).
4.
Ensure that leak detector will be operating in an environment free of tracer gas.
5.
Check the electrical network is properly attached to the connector using the power
cable.
1.
Connect the necessary accessories or equipment before powering on the device.
Operating Mode
Connect to device
Sniff mode
Sniffer probe on vacuum chamber flange
Vacuum mode
Test object
Any test mode
Accessories needed per test
2.
To power on the VERSA C, the user must power on their external pump prior to
switching on the leak detector.
