25
OPERATIONAL INSTRUCTIONS
1- Plug the machine into a 220-240 VAC/50Hz power supply outlet.
2- Add water to the tank using the container included Keep the water within the minimum and
maximum limits.
3- Press “ON” to switch the machine on.
4- Water is pumped from the tank to the water tray This process will take 30 seconds.
NOTE:
If the water is not pumped after two cycles and the level of water is sufficient, open the
bleed valve and let a small quantity of water out. Then, switch the machine on by pressing the
“ON” button.
5- The evaporator starts to make ice in the water tray. During the first 3 cycles, the conical shaped
ice-cubes can be small and irregular.
6- The making cycle will last from 6 to 18 minutes depending on the temperature of the water.
After having completed the cycle, the water tray will tip forward, the rest of the water will flow once
again to the water tank and the ice-cubes will fall into the ice container.
7- After 30 seconds and after the water level has stabilised, the making cycle starts again.
8- Press “OFF” to stop the making cycle.
NOTE:
To obtain better performance, the water temperature should be between 7ºC and 15ºC
and room temperature between 15ºC and 28ºC. We recommend changing the water every 24 h.
SWITCHING ON/OFF PROGRAMMING
1- Adjust the clock: Press the “TIME” button once and press "SET" to change the hours. Press
“TIME” twice and press “SET” to change the minutes. After the adjustment, the time will stabilise
alone.
2- Switching on: Press the “TIME” button three times to adjust the hours and four times to adjust
the minutes. After 5 seconds, the “ON” indicator will switch off. Press “SET” twice and the “TIME”
and “ON” indicators will come on.
3- Switching off: Press the “TIME” button three times to adjust the hours and four times to adjust
the minutes. After 5 seconds, the “ON” indicator will switch off. Press “SET” twice and the “TIME”
and “ON” indicators will come on.
CLEANING / MAINTENANCE
1- Before proceeding with the cleaning, make sure that the device is unplugged.
2- Do not use aggressive products or metallic sponges that can harm stainless surfaces for
cleaning. Make sure of drying all the elements before re-assembling them.
