CE User Manual
LACROS 1.9 EN
40
Maintenance
Your e-bicycle needs regular maintenance. Shinga B.V. or your Lacros dealer can advise you on optimal use
and maintenance. If you have any questions or problems with your e-bicycle, don't hesitate to contact the
Lacros dealer or Shinga B.V.
We recommend the first service of your bicycle after 1000 km. After this, we recommend you come by every
2500 km or annually with your bike for service. To extend the life of your bicycle, we recommend keeping the
chain and derailleur clean and lubricating your chain with chain oil once every 3 months. Check the screw
connections regularly and tighten them if necessary. We advise you always to use original components for
your safety if parts need to be replaced. These components are for sale at Shinga B.V. or your Lacros dealer.
For maintenance instructions, you can consult the Lacros by Shinga YouTube page, which can be found at
www.youtube.com/ShingaBicycles. Here you will find, among other things, videos with instructions for
adjusting your brakes, changing brake pads, and tensioning the chain of a Scamper S600 (XL).
Legal Requirements
According to European legislation, the described vehicle is an electric bicycle because the vehicle complies with the
following rules:
•
From 6 km/h, the support is only active when the user pedals himself;
•
the support is active up to a maximum of 25 km/h;
•
the maximum delivered power is equal to 250 Watts.
According to Dutch law, the described vehicle is a bicycle because the vehicle has the following parts:
•
two independent, well-functioning brakes;
•
front light with white or yellow light & rear light with red light and reflector;
•
wheel reflector and/or reflective tires and/or reflective rims;
•
pedals with yellow reflectors.
Environment
Following the environmental regulations for the intake and processing of batteries of the Dutch Ministry of VROM,
we advise you always to return the battery to your Lacros dealer or Shinga B.V. They are obliged to collect the
battery and take care of the further processing of the battery.
