Receiving the DCF Time Code
The projection clock will automatically receive the DCF time code every hour.
Besides, you can force the clock to receive the signal by pressing
“
Wave” for 3
seconds. It will take 3-5 minutes to receive the radio signal. It the time signal is
received, the [ ] icon will be on otherwise it will be off.
Attention! Please dispose of used batteries in an ecologically safe manner.
Liability Disclaimer:
-The electrical and electronic wastes contain hazardous substances. Disposal of electronic waste in wild
country and/or in unauthorized grounds strongly damages the environment.
-Please contact your local or/and regional authorities to retrieve the addresses of legal dumping grounds with
selective collection.
-All electronic instruments must from now on be recycled. User shall take an active part in the reuse,
recycling and recovery of the electrical and electronic waste.
-The unrestricted disposal of electronic waste may do harm on public health and the quality of environment.
-As stated on the gift box and labeled on the product, reading the “User manual” is highly recommended for
the benefit of the user. This product must however not be thrown in general rubbish collection points.
-The manufacturer and supplier cannot accept any responsibility for any incorrect readings and any
consequences that occur should an inaccurate reading take place.
-This product is designed for use in the home only as indication of the temperature and other weather data.
-This product is not to be used for medical purposes or for public information.
The specifications of this product may change without prior notice.
-This product is not a toy. Keep out of the reach of children.
-No part of this manual may be reproduced without written authorization of the manufacturer.
