Channel 4 controls the high and
low speed servo:
12
www.LAEGENDARY.com
Radio System
- Press the left button on the remote to
pull the winch cord out. Release the button
and the winch motor will stop.
-
Press the right button on the remote to
wind the winch cord back. Release the
button and the winch motor will stop.
Channel 5 controls the winch:
- Insert the H/L speed servo connector to
the 4th channel of the receiver. Make sure
the polarity is correct. The pin on the left
side of the receiver is the signal pin;
the middle one is the positive and the
right side is the negative.
- The CH4 slide switch has 2 positions:
right position for low speed and left
position for high speed.
IMPORTANT!
In order to protect the gears, use the CH4
slide switch when the car is stopped.
If the wheels are not running after sliding
the switch, switch back and try again.
High
Low
CH5
