Torso
1
. Chest compressions:
The manikin presents the correct
anatomical landmarks for external chest compressions.
2. Defibrillation:
The manikin is equipped with two defibrillation
connectors and four lead connectors for use with AEDs or
manual defibrillators. The ECG signal can also be monitored
across these connectors. Using the remote control, the instructor
can select the “ignore defib” function to control whether or not
the defibrillation shall result in conversion to a perfusing rhythm.
Paddle adapters are supplied for use with manual defibrillators.
Note:
Defibrillation must be performed over the two defib
connectors only as shown in figure 1.
3. Stomach:
The manikin is equipped with a stomach and pressure
valve system that allows stomach distension at inspiratory
pressures of more than 25 cmH2O. To deflate press gently on
the stomach as shown in figure 2.
4. Power Supply:
The manikin is intended to operate from battery
power. An AC power adapter is included in the event the user
prefers not to use battery power (110 – 240V AC).
Connect the power adapter to the manikin as shown in figure 3.
Remote Control
Communication between the remote control and the manikin
is based on low power radio frequency (RF) communication.
If the remote control device is used in an environment where
RF communication is not desirable, or where interference from
other sources makes the remote control device inoperable, it is rec-
ommended to use the cable connection between the remote con-
trol and the manikin. Using the direct cable connection
disables the RF circuits in both the remote control and the manikin.
For use of this cable see later section.
Overview of the Remote
Control Device
A. LCD display:
Displays status
and operation information.
B. Quick execution buttons:
Function keys.
The function of each
button is labeled on the display
above the button.
C. Navigation keys:
Use keys to navigate
and select functions
on the display.
D. OK/Select key:
Use this key to activate
selected functions.
E. Cancel/Back key:
Go back from sub menus without any changes.
F. Numerical keys:
Use these keys to enter numerical data or to
select numbered parameters. Can also be used as alphanumerical
keys to enter file and event-names
G. Menu/Setup:
Enter Setup Menu.
H. Scenario:
Use this button to start a scenario.
I. Shift key
J. On/Off key:
Press once to turn the unit on.
Press again to turn the unit off.
For Remote Control to properly recognize the manikin
1
.
Turn on the manikin by pressing the
On/Off
button located on
the right side of the manikin’s torso as shown in figure 5.
2.
Turn on the remote control by pressing the
On/Off
key
(indicated by the letter J in remote control figure 4). The remote
control will automatically detect the manikin and set the initial
parameters accordingly. A splash screen will be displayed for a
few moments until the main display is shown.
Note:
If an error message appears stating “no reception”, make sure
that the manikin is turned on.
I
H
G
B
C
D
E
F
J
A
5
Figure
1
Figure 2
Figure 5
E
N
G
L
IS
H
Figure 4
Figure 3
On/Off
RA Adv skilltrainer_Multi:RA Advanced skilltrainer_Multi.qxd 02.09.2008 07:55 Page 5
