© copyright 2005
(P/N)12-249 v2 • 9/08
Kaba Mas LLC
page 5 of 8
SENDING SET-UP TO THE LOGIC MODULE
This function requires the use of the Logic Module Programming Cable (P/N 43097) and a Serial Interface Connector.
1. Connect power to the Logic Module. (Requires the use of a 9V battery.) Duracell
TM
or Eveready
TM
batteries are recommended.
2. Plug Interface and cable into PC and open SMARTLINC Set-up Software.
3. Connect the 43097 cable to the Logic Module through the port on the keypad.
4. Press the Send button on the software (see Screen 12).
5. The software will instruct you to activate the PC Link in the Master Menu on the Logic Module (see screen 13).
NOTE: This reminder screen will display even if PC Link is already activated.
6. Press any key to power up SMARTLINC.
• Display will show either “ENTER COMBO” or “SELECT LOCK” when two or more locks are installed.
7. Hold down “zero” until the display shows “MASTER, X-X-X-X-X-X-X-X”
8. Enter the MASTER code.
9. Press the “P” button four (4) times to select PC Link; the display will show “PC LINK”. Press the OK button to start communication with
the PC.
10. On the screen the software will scroll through each Record number as it downloads, then it will show OK.
• In order to exit from PC Link, press the “P” button three (3) times. When the screen reads “Do you want to QUIT?” press the “OK” button
to exit.
NOTE: If the computer does not have a serial port, a serial to USB connector will be required.
DST (Daylight Savings Tine) SET-UP
This function requires the use of the Logic Module Programming Cable (P/N 43097), PC, DST Update Software and a Serial
Interface Connector.
1. To set-up DST, click on the DST icon on the PC desktop. The set-up window will appear (see Screen 14). In this window, set up the DST
dates or select from the pre-set files available. A pre-set file has been created for the USA.
2. Click File from the menu bar, then Open.
3. Select the file marked USA.DAT and click Open (see Screen 15).
• The dates will automatically be filled in for the next 15 years (see Screen 16).
NOTE: This program will also allow the DST file to be deleted from a previously programmed Logic Module in the event the Module
must operate in a state not having DST.
Screen 12
Screen 14
Screen 16
Screen 15
Screen 13
