C
H
A
N
G
N
G
T H
E
B
E
L
T
9
Place the new V-belt on the sanding plate disco
10
Push the parts into the attachment. Make sure that
the sanding plate can be rotated by hand and that the
V-belt was correctly installed in the attachment.
11
Rotate the hole pattern of the sanding plate bearing
piece so that it fits the hole pattern of the attach
ment and then insert the three screws.
12
Use a cross-tip screwdriver to tighten down the
three screws.
13
Then place the attachment on the machine by
inserting the V-belt into the motor belt pulley first
and then the attachment on the machine.
14
Then screw the hexagonal nuts SW 1 3 onto the
threaded studs. Make sure that washers are instal
led under the hexagonal nuts.
15
Now tighten the V-belt as described in section 6.1.
Following a running-in period, check the belt again!
6.3
Renewing the attachment belt pulley
If, when the V-belt is being changed, it is determined that
the attachment belt pulley is worn-out, you must pro
ceed in the following manner:
1
Switch off the machine and pull out the power
supply plug.
2
Dismantle the attachment from the machine in
accordance with section 6.2. Afterwards, remove
the sanding plate bearing piece.
3
Hold down the belt pulley firmly with your hand and
unscrew the axle using a wrench SW 13 (Attention!
- left thread).
4
Install the new belt pulley and rotate until tightened
down firmly.
5
Re-assemble the attachment again in the reverse
order of steps in accordance with section 6.2.
Fig. 27 T
he V·belt must be Iying in the mo tor belt pulley; ...
Fig. 28
...
before tightening the bell, determine wh e ther
the sanding disc is rotating the motor as weil.
Lägler
15
