8. Troubleshooting
T R
O U
B L E
S H
O
O T
N
G
This section shows you how to eliminate possible
malfunctions. In case none of the measures mentioned
here are not successful, please contact LÄGLER or your
local dealer. Your local dealer is very familiar with the
ELAN machine and is a highly qualified expert trained by
our company. Your local dealer will provide you with the
best possible advice and support.
Machine does not run
The machine does not start
•
Check the power supply system and the fuse.
•
Let the electrical equipment be checked by an
electrician (e.g. switches, motor cable) .
•
Machine has been switched off by means of the
thermal sensor and must cool off.
The machine tries to start but is blocked
•
At low temperatures: Heat up the machine to room
temperature in a warm room.
•
Low voltage: Check the cable quality and cable
length. Avoid the use of cable cross-sections that
are too small and power supply cables that are too
long. Use a transformer (art. no. 708. 00. 00. 100) for
230 V as required.
•
Check and adjust the V-belt tension.
Machine runs badly
Machine runs, but no or very little sanding power capa city
•
At low temperatures: Heat up the machine to room
temperature in a warm room.
•
Low voltage: Check the cable quality and cable
length. Avoid the use of cable cross-sections that
are too small and power supply cables that are too
long. Use a transformer (art. no. 708. 00. 00. 100) for
230 V as required.
•
Check and adjust the V-belt tension.
•
Check the driving elements for free-running conditi
on.
•
Setting-against angle is too flat.
•
Incorrect or dull sanding disco
Machine vibrates extremely and works noisily
•
Check the sanding disc for damage.
•
Check the belt drive unit.
•
Check the machine for clogged and deposited mate
rial.
21
