Lagler Flip, Handling, Maintenance, Safety

6

Note:

The motor data mentioned above refers to

machines used in the Federal Republic of Germany.

Exported machines may have other data that can

be seen on the motor type designation plate.

TECHNICAL DATA

2

Note:

The values mentioned above are emission

values and must not represent safe workplace

values as well. Although a correlation exists

between emission levels and immission

levels, it is not always possible to determine

whether additional precautionary measures

are required. Factors that can have an effect

on the immission level existing at the

workplace include the duration of the effects,

the characteristics of the work area and other

sources of noise, e.g. the number of machines

and other processing operations in the

vicinity. The permissible workplace values

may also vary from country to country. This

information, however, is intended to enable

the user to estimate the dangers and risks

better.

Technical data

Manufacturer ....................................................... Eugen LÄGLER GmbH

Machine type ..................................................... edge-sanding machine

Serial number .................................................................. see rating plate

Year of manufacture ...................................................... see rating plate

Motor type ........................................................................ universal motor

Voltage ................................................................................................... 230 V

Frequency ................................................................................... 50 / 60 cps

Output ............................................................................................... 1.35 kW

Fuse .......................................................................................................... 10 A

Insulation class ........................................................................................... F

Protection class ................................................................................... IP 22

Protection system ...................................................................................... 2

Safety devices ......................................................... no-voltage release

.................................................................... thermal overload protection

Sanding disc diameter ..................................................... Ø 150 mm (6“)

Sanding disc diameter, corner attachment .......... Ø 61 mm (2 3/8“)

Sanding disc speed under load ............................. approx. 3100 rpm

Sanding disc speed under load,

corner attachment ...................................................... approx. 7750 rpm

Attachment height without wall-protecting roller ... 44 mm (1 3/4“)

Attachment height with wall-protecting roller ......... 58 mm (2 1/4“)

Height corner attachment ................................................... 51.5 mm (2“)

Attachment length, short version ............................... 155 mm (6 1/8“)

Attachment length, long version ............................... 315 mm (12 3/8“)

Length corner attachment ............................................ 225 mm (8 7/8“)

Overall height without dust bag ................................ 460 mm (18 1/8“)

Overall length without dust bag

- with short attachment ............................................... 460 mm (18 1/8“)

- with long attachment ................................................. 620 mm (24 3/8“)

- with corner attachment ............................................ 530 mm (20 7/8“)

Overall width ................................................................... 260 mm (10 1/4“)

Total weight ....................................................................... 9.8 kg (21.6 lbs)

Dust emissions at workplace ............ < 0,2 mg/m

3

 (0.0024 gr./cu.yd.)

Workplace-related noise emission values ........................ 86 dB (A)

Vibration total value a

hv

.....................................................................................................

< 2.5 m/s²

  (measured at the handle)

Application purposes

Dry edge-sanding and stair-sanding of wooden floors and cork

floors.

Not to be used for any wet processing operations!

Pricing in this catalog is outdated