FLIP
®
01.12.2012
English / Englisch
4.3 STARTING THE MACHINE
CAUTION!
RISK OF INJURY and RISK OF PROPERTY DAMAGE from rotating
parts of the machine:
•
Always tip the machine backwards slightly (Fig. 7) before
starting the machine so that the sanding disc is raised off
the floor!
•
Never allow the machine to run unattended!
1
Tip the machine backwards slightly (Fig. 7).
2
Flip the rocker switch to “I” (Fig. 8, 1.). The switch button will
snap into the place and the motor will be started.
3
Tip the machine forward and begin sanding.
CAUTION!
RISK OF PROPERTY DAMAGE:
If the switch button does not snap into switch position “I”, do
not continue sanding! Otherwise the motor can be permanently
damaged!
Remedy the following causes for the malfunction:
•
The electrical network has undervoltage! Use a transformer
if necessary.
•
The extension cable is too long (longer than 20 m or the
cable cross-sections of the extension cable are smaller
than 1.5 mm²!
•
The carbon brushes of the motor have reached their wear
limit and must be replaced (
Section 7.6, Replacing the
carbon brushes
).
•
The switch is defective! It must be replaced by a qualifi ed
electrician (circuit diagram
Section 10
)!
COMMISSIONING
4
Fig. 8
Start (1.) and switch off (2.) the machine using the
rocker switch.
Fig. 7
Tilt the machine backwards slightly before starting
and switching off the machine.
14
Summary of Contents for Flip
