FLIP
®
01.12.2012
English / Englisch
Fig. 12
Remove the screw with the universal spanner.
Fig. 13
Remove the screw and the paper tensioning disc
(1.) and remove the sanding disc (2.).
5.2.2 CONVENTIONAL SANDING DISCS
1
Switch off the machine.
2
Pull the power plug out of the socket!
3
Lay the machine on its side, avoiding damage to the floor and
the machine!
4
Use the universal spanner to remove the screw from the
sanding plate (Fig. 12).
5
Remove the screw and paper tensioning disc (Fig. 13, 1.).
Remove the sanding disc from the sanding plate (Fig. 13, 2.)
and put all three parts aside.
6
Put on a new sanding disc and insert the screw with the paper
tensioning disc into the hole of the sanding plate (Fig. 14, 1.).
7
Turn the screw in the sanding plate with the universal spanner
(Fig. 14, 2.). Make sure that the sanding disc is as centred as
possible on the sanding plate.
8
Tighten the screw with the universal spanner until it is hand-
tight.
ATTENTION!
Do not tighten the screw for attaching the sanding disc too
tightly! The thread of the sanding plate could otherwise be
damaged!
WORKING WITH THE FLIP
®
5
Fig. 14
Mount the new sanding disc (1.) and tighten the
screw (2.).
18
Summary of Contents for Flip
