FLIP
®
01.12.2012
English / Englisch
Fig. 59
Steeper adjustment angle for rough sanding work.
Fig. 60
Flat adjustment angle for fine sanding work.
MAINTENANCE WORK AND REPLACEMENT OF WEARING PARTS
7
7.8.2 SETTING FOR SPECIAL CASES
To sand deeper for rougher sanding work, no additional pressure
may placed on the attachment; instead the adjustment angle must
be made steeper (Fig. 59)!
For finer sanding work, the adjustment angle can be made flatter
(Fig. 60).
The standing setting can easily be restored using the universal
spanner.
If you would like a steeper or flatter setting than the standard set-
ting, proceed as follows:
1
Switch off the machine.
2
Pull the power plug out of the socket!
3
Loosen the locknut of the guide roller to be adjusted (Fig. 51,
A).
If the locknut is screwed on too tightly, you can turn the guide
roller counterclockwise with the universal spanner to loosen
the locknut (Fig. 51, B).
4
Now turn the guide roller one or two rotations in the desired
direction.
5
Retighten the locknut.
6
Adjust the second guide roller.
7
Conduct a trial sanding operation and check the sanding
results (
Section 7.8.1, Standing setting
steps 9 to 11).
37
Summary of Contents for Flip
