FLIP
®
01.01.2019
English / Englisch
CAUSES OF FAULTS
9.4 THE MACHINE VIBRATES INTENSELY AND
RUNS NOISILY
•
The sanding medium does not have the proper tension. The
tension must be corrected.
Section 5.2, Replacing the sanding medium
•
The sanding medium is damaged or incorrect and must be
replaced.
S
ection 5.2, Replacing the sanding medium
•
The V-belt is dirty, damaged or worn-out and must be
replaced.
Section 7.3, Replacing the V-belt
•
A pulley is dirty, damaged or worn-out and must be cleaned
or replaced.
Section 7.4, Replacing the complete sanding plate
Section 7.5, Replacing the motor pulley
•
There are clogged materials and deposits in the machine
that must be removed.
Section 7.1, Cleaning and care
9.5 THE MACHINE RUNS BUT CREATES A GREAT
DEAL OF DUST
•
The dust bag is more than one third full and must be emptied.
Section 5.3, Emptying the dust bag
•
The dust bag is not correctly attached or is damaged and
must be replaced.
Section 4.1, Preparing the machine
•
When mounting the attachment, the belt tightening plate was
pinched between the attachment and the fan housing. The
attachment must be properly installed.
Section 7.3.2, Installing the V-belt
•
There are clogged materials and deposits in the machine
that must be removed.
Section 7.1, Cleaning and care
•
More than one sanding disc is mounted. Only install one
sanding disc.
Section 5.2, Replacing the sanding medium
•
The machine setting angle is too steep. The guide rollers
must be properly adjusted.
Section 7.8, Adjusting the guide rollers
9
48