HUMMEL
®
01.12.2012
English / Englisch
COMMISSIONING
5
Lift the sanding drum off the floor by turning the lowering
lever at the handle upwards (Fig. 5).
6
Hook the cable support into the bracket at the top of the guide
tube (Fig. 6)
7
Fasten the dust bag firmly using the cord and the MultiClip
at the end of the guide tube (Fig. 7). Ensuring when mounting
that the opening of the guide tube is not closed.
8
Release the cover lock (Fig. 8, 1.) and remove the side cover
on the right of the machine housing (Fig. 8, 2.).
9
Pull the operating lever of the drive unit upwards (Fig. 8, 3.).
This will lower the tensioning roller.
10
Position the sanding belt on the tensioning roller of the drive
unit (Fig. 9) and push it over the tensioning roller and the
sanding drum (Fig. 10).
Fig. 6
Hook the cable support into the bracket at the
guide tube.
Fig. 7
Mount the dust bag using the cord (1.) and the
MultiClip (2. and 3.) at the end of the guide tube.
Fig. 8
Release the cover lock (1.), remove the side
cover (2.) and lower the tensioning roller by pulling
up the operating lever (3.).
Fig. 9
Position the sanding belt on the tensioning roller
of the drive unit.
Fig. 10
Push the sanding belt far enough over the sanding
drum and tensioning roller so that the sanding
drum is fully covered by the sanding belt.
4
Fig. 5
Lift the sanding drum off the floor by turning the
lowering lever at the handle upwards.
13
Summary of Contents for HUMMEL
