10
STARTING THE MACHINE
Fig. 10
Tension the sanding belt by lowering the tension-
ing lever.
3.2 STARTING THE MACHINE
Once the preparatory stages have been completed, the machine can
be started. To start the motor, the switch must be held for around
2 seconds in the -START- position until the motor has reached full
speed.
Remaining for too long in the -START- switch position shortens the
service life of the starting capacitor! Once the motor has reached
its full speed, release the switch button. The switch will then auto-
matically move to the -WORKING- position.
If the motor should ever be difficult to start in extremely cold con-
ditions, the V-belt tension should be relaxed by loosening the eye
bolt. Lower belt tension will allow the motor to start up more easily.
Once the motor is up to temperature, remember to retension the
belts using the eye bolt.
3.3 SWITCHING OFF THE MACHINE
To switch off, raise the sanding drum off the floor by actuating the
lowering lever and turn the switch button to the -0- position. Wait
until the sanding drum comes to a standstill before replacing the
machine down onto the sanding drum. Never allow the machine to
run unattended and always pull the mains plug out of the socket
once you have finished working.
3
ATTENTION!
Never switch on the motor before tensioning the sanding belt!
Never switch on the motor unless the sanding drum is raised
off the floor!
Never allow the machine to run unattended, and always pull the
mains plug out of the socket once you have finished working!
Summary of Contents for HUMMEL
