SINGLE 01.02.2013
English / Englisch
WORKING WITH THE SINGLE
Working with the SINGLE
For more information free of charge, please
apply to:
within Germany
- Tel.: 0800 / 52 34 537
- Fax: 0800 / 48 66 353
within the USA
- Tel.: 800-848-6635
or
- Tel.:
0049 - 7135 - 98 90-0
- Fax:
0049 - 7135 - 98 90-98
- e-mail:
info@laegler.com
- Internet:
http://www.laegler.com
4.1 GENERAL APPLICATION TIPS
It is possible to avoid leaving deep sanding tracks caused by exces-
sively coarse abrasion grain size by initially selecting a fine grain
size for the first sanding process.
Carry out a test sanding process using a 50 or 60 grain size. If this
test is satisfactory and you envisage a good sanding result within
a reasonable period, it is more efficient to start the sanding work
off with these finer grain sizes. This is the best way to avoid leaving
deep sanding tracks caused by an excessively coarse grain size.
You can avoid creating sanding tracks from the previous grain size
used by adhering to the grain size sequence and not skipping more
than one grain size at a time.
After each sanding pass, vacuum the floor thoroughly. Keep the
machine’s wheels clean.
When changing to a new sanding disc, always start work in a less
well lit area of the room until the sanding disc loses its initial ag-
gressive sanding effect.
For other informative and important application tips, please refer
to the LÄGLER
®
application technology brochure „Sanding wooden
floors“!
4.2 CHANGING THE SANDING PLATE
1
Switch off the machine.
2
Pull the mains plug out of the socket.
3
Pull the adjusting lever on the handle towards you to release
the lock of the guide tube, and push the guide tube into and
past the vertical position until it reaches the mechanical stop
(Fig. 13).
Fig. 12
Do not start the machine in this position unless
- the sanding plate is placed flat on the floor AND
- the dust extraction socket is closed either with
its cap or a vacuum cleaner hose!
Then pull both the start levers AT THE SAME TIME.
Fig. 13
Pull the adjusting lever to release the lock and
push the guide tube up until it reaches the me-
chanical stop.
4
11
Summary of Contents for SINGLE
