SINGLE 01.06.2019
English / Englisch
For safety reasons, the machine CANNOT be switched on if:
•
the guide tube is in a
vertical position
, since this makes the
machine very difficult to control (fig. 13).
•
both start levers on the handle are
not
pulled
at the same
time
.
Holding the machine steady with both hands enables you to
control the machine properly when it is switched on, despite
the motor starting torque.
Before switching on the machine, ensure that:
•
all tools and adjustment tools have been removed from the
machine,
•
the machine is in the working position,
•
the sanding plate is placed completely flat on the floor,
•
the guide tube is
not in a vertical position
,
•
the dust extraction socket is closed either with its cap or
with a vacuum cleaner hose,
•
you are in the middle of the room with the machine, as far
away as possible from other persons or obstacles!
4.3.2 SWITCH-ON PROCEDURE
When you have made the checks mentioned in
Section 4.3.1,
General
, the SINGLE can be started as follows:
1
Pull both the start levers
at the same time
and hold the handle
tight with
both
hands (fig. 14).
2
The machine will start up.
NOTE:
To start up the machine with almost no jerking movement,
we recommend lifting the machine
slightly
at the handle
immediately after you switch it on.
COMMISSIONING
4
Fig. 14
Only switch on the machine in this working
position, when
- the sanding plate is placed completely flat on
the floor
and
- the dust extraction socket is closed either with
its cap or with a vacuum cleaner hose!
Then pull both the start levers
at the same time
!
!
Fig. 13
ATTENTION:
If the guide tube is in a
vertical
position
, the machine
cannot
be switched on!
22
