UNICO 01.02.2013
English / Englisch
Fig. 17
Installing the handlebar on the pipe bend.
Fig. 16
Undoing the clamping lever at the pipe bend and
removing the extension.
Fig. 15
Removing the handlebar.
Fig. 14
Undoing the clamping lever on the extension.
4.5.2 REMOVING THE EXTENSION
Whenever you want to work in a stooped or kneeling position, you
can also remove the extension and fasten the handlebar directly
to the pipe bend:
1
Switch off the machine.
2
For safety reasons, always pull the power supply plug out
of the socket to prevent the machine from being started up
unintentionally!
3
Undo the clamping lever at the upper end of the extension
(Fig. 14).
4
Pull the handlebar out of the clamping piece and remove it
upward (Fig. 15). Put the handlebar aside.
5
Undo the clamping lever at the front end of the pipe bend and
pull the extension upward out of the bracket (Fig. 16). Put the
extension aside.
4.5.3 INSTALLING THE HANDLEBAR
The handlebar can be installed on the pipe bend in vertical position
as well as in horizontal position.
Handlebar in vertical position:
1
Remove the extension first, as described in the preceding
Section 4.5.2
.
2
Install the handlebar directly in the bracket on the front end
of the pipe bend (Fig. 17). Tighten the clamping lever again.
Handlebar in horizontal position:
3
Use the enclosed Allen key to undo the screw on the angle
clamping connector of the pipe bend and then rotate the angle
clamping connector by 90° (Fig. 18).
4
Use the Allen key to tighten the screw of the angle clamping
connector again.
4
COMMISSIONING
16
Summary of Contents for UNICO
Page 46: ...UNICO 01 02 2013 English Englisch SPARE PARTS 46 11...
Page 48: ...UNICO 01 02 2013 English Englisch SPARE PARTS 48 11...
Page 50: ...UNICO 01 02 2013 English Englisch SPARE PARTS 50 11...
Page 52: ...UNICO 01 02 2013 English Englisch SPARE PARTS 52 11...
