UNICO 01.07.2019
English / Englisch
Fig. 47
Simply pull off the worn-out Velcro sanding disc.
Fig. 46
Place the UNICO down on the
left-hand
side only.
5
WORKING WITH THE UNICO
Fig. 48
To center the sanding disc, insert the Allen key
into the hole of the sanding disc and then into
the hexagon socket of the sandpaper tensioning
screw.
You will use various grain sizes of the abrasive depending on the
sanding work in each case. To replace the abrasive, proceed as
follows:
5.2.1 REPLACING VELCRO SANDING DISCS
1
Switch off the machine and pull the power plug out of the
socket!
2
Place the UNICO on its side by grabbing the machine by the
handlebar on the right-hand side and then tilt the machine
over to the
left-hand
side (fig. 45) and set it down carefully.
Always
set the UNICO down on the
left-hand
side (fig. 46)!
This will prevent damage to the floor.
3
Pull off the worn-out Velcro sanding disc from the sanding
disc wheel (fig. 47).
4
Use the proper Allen key or other suitable tool and insert it
through the small hole of the new Velcro sanding disc.
5
Set the Velcro sanding disc in place by inserting the Allen
key in the hole of the sanding disc first and then into the
hexagon socket of the sandpaper tensioning screw (fig. 48).
Then move the sanding disc up to the sanding disc wheel
so that it rests precisely in centered position on the sanding
disc wheel.
6
Remove the Allen key or the centering tool you have used
and press the disc evenly onto the Velcro disc wheel. Store
the centering tool in a safe place.
Fig. 45
Tilt the UNICO over to the
left-hand
side and set
it down carefully.
32
