Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
976200-2, 976202-2
21
REV112019
Daily Maintenance
•
Check and/or add oil to head feed cylinder as needed.
•
Empty chip drawer.
•
Add 2 pumps of oil to way oilers.
Weekly Maintenance
•
Check and add coolant as needed.
•
Check and add oil for way oiler.
Monthly Maintenance
•
Check and add oil to the air regulator oiler as needed.
•
Change out coolant.
•
Check gibs and vise gibs.
100 Hour Maintenance
•
Change gear box oil after first 100 hours of operation.
6 Month Maintenance
•
Change gear box oil.
•
Adjust gibs and vise gibs if needed.
MAINTENANCE FOR NON-FERROUS HEAD
•
Gear Box: The gear box does not require any oil. The horizontal spindle has zerk fittings
provided for lubrication. The spindle should be greased with a high quality, high
temperature grease.
•
Air Oiler: Located in the air regulator must be dry and clean. Use appropriate measures
to ensure this before air enters the machine.
•
Head Feed Cylinder: The oil reservoir is mounted into the cylinder. The reservoir is clear,
and you can visibly inspect the oil level. When oil is approximately 1/4” in depth more oil
must be added.
o
To fill reservoir, remove the brass cap on top and add oil in to the reservoir until
full cycle head begins to bleed.
•
Chip Drawer: Located behind the front access door, this drawer pulls out for easy
cleaning. If a chip collection unit has been installed to the back of the machine, it should
be emptied regularly. Chips will also build up within the vertical column which will need to
be cleared.
•
Coolant Pan: Located under chip drawer. The coolant should be kept clean. When
coolant needs changing, remove the drain plug from the pan.
