Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
976200-2, 976202-2
22
REV112019
•
Way Oiler: This reservoir is on the back of the column and needs to be kept full. At the
beginning of each shift, this should be pumped twice to maintain good lubrication for the
ways.
•
Gib Blocks: This acts as an adjustable guide for the gear box.
•
Vise Gib Block: Can be adjusted by loosening the lock nuts and turning the set screws
equally. This should be done whenever the vise shifts left or right when clamping.
•
Belt Tensioning should be done as needed.
1. Loosen the four motor mounting bolts.
2. Using the adjusting bolt threaded in to the block on the motor panel adjust as
needed.
3. Tighten motor mounting bolts securely.
Note:
If there is no adjustment left in the threads the belt may be stretched and in
need of replacement. Belt tension should have approximately 1/4"-3/8” deflection.
On occasion if adjustment is not possible loosen the motor mounting bolt and
reposition the motor and try adjustment.
Daily Maintenance:
•
Clean chips out of the vertical column.
•
Check and/or add oil to head feed cylinder as needed.
•
Empty chip drawer.
•
Add 2 pumps of oil to way oilers.
Weekly Maintenance:
•
Add grease to spindle as needed.
•
Check and add coolant as needed.
•
Check and add oil for way oiler.
Monthly Maintenance:
•
Check and add oil to the air regulator oiler as needed.
•
Change out coolant.
•
Check gibs and vise gibs.
6 Month Maintenance:
•
Adjust gibs and vise gibs if needed
