Dake Corporation
1809 Industrial Park Drive
Grand Haven, MI 49417
12
983113
REV112020
OPERATION STEPS:
•
Before use, make sure that the position of the lower limit screw (B) is correct.
•
Make sure that the lower limit screw (A) of the saw blade is at the tooth surface of the blade
below the work surface.
•
Make sure that the screw position of the lower limit switch is so that the band saw reaches the
lower limit position and the power is turned off immediately to stop the band saw.
1. Turn the on/off control valve (B) on the hydraulic
cylinder to the 90
º
position. Close and lock the
hydraulic cylinder and hold the handle (A) to raise
the saw bow about 5 inches high.
2. Place workpiece between the vice, clamp down to
secure the work, and adjust the height of the bow
up or down to ensure the blade is 1 inch about the
working height.
3. After confirming that the workpiece is clamped, start
the sawing belt. Please select a different cutting
speed according to the material of the workpiece
(refer to next section).
4. Turn the throttle valve of the hydraulic cylinder to the 0 position (clockwise to the
bottom), close the hydraulic cylinder, and then open the on-off valve to the 0-degree
position. At this time, the bow will not drop. (When the on-off valve is opened, the saw
bow will not descend, because the throttle valve is set to 0, closed position) (the throttle
valve at 0 position alone, cannot stop the saw, bow does not lower, it may be oil (Caused
by damage to the cylinder).
5. Slowly open the throttle valve of the hydraulic cylinder (turn counterclockwise) to adjust
B
A
