Dake Corporation
1809 Industrial Park Drive
Grand Haven, MI 49417
9
983113
REV112020
WORKING ENVIRONMENT
•
Keep work area clean. Cluttered areas and benches invite accidents.
•
Do not use in dangerous environment. Do not use power tools in damp or wet locations or
expose them to rain. Keep work area well-lighted.
•
Keep children and visitors away. All children and visitors should be kept a safe distance from
work area.
•
Do not install or use this machine in an explosive, dangerous environment.
MAINTENACNE
•
Disconnect machine from power source when making repairs.
•
Check damaged parts. Before further use of the saw, a guard or other part that is damaged
should be carefully checked to ensure that it will operate properly and perform its intended
function check for alignment of moving parts, binding of moving parts, breakage of parts,
mounting, and any other condition that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
•
Disconnect tools before servicing and when changing accessories such as blades, bits,
cutters, etc.
•
Make sure that the blade tension is properly adjusted. Green LED will light when properly
tensioned. Saw will not operate until green light is lit.
•
Re-check blade tension after initial cut with new blade.
•
To prolong blade life always releases blade tension at the end of each work day.
•
Check coolant daily. Low coolant level can cause foaming and high blade temperatures. Dirty
or weak coolant can clog pump. This can cause low cutting rate and permanent blade failure.
Dirty coolant can cause the growth of bacteria with ensuring skin irritation.
•
When cutting magnesium never use soluble oils or emulsions (oil-water mix) as water will
greatly intensify any accidental magnesium chip fire. See your industrial coolant supplier for
specific coolant recommendations when cutting magnesium.
•
To prevent corrosion of machined surfaces when a soluble on is used as coolant, pay
particular attention to wiping dry the surfaces where fluid accumulates and does not evaporate
quickly, such as between the machine bed and vise.
SPECIFIC USAGE
-
This machine is used for general metals cutting within the range of cutting capacity.
SAFETY DEVICE
-
By the time the saw arm cover is opened, the interlock switch will function to stop the all
involvement. Do not remove this switch from machine for any reason and check its function
frequency.
