Part# VDL-18
32
REV#082020
Loosen the rear guide clamp screw and push
the guide forward so that it just touches the
back of the blade. Tighten the guide in position.
Rotate the blade by hand and check to see that the
back of the blade does not hit the blade guide with a
bad weld..
Note:
You will probably find that the guides can be
adjusted more easily by tilting the table to 45
degrees.
Note:
Rotate the back guide by approximately 15
degrees after every 8 hours of use. This will greatly
extend the life of the back-blade guide, as it will
even out the wear
Before you cut any metal or wood, read the safety
rules at the front of this manual
Table tilted 45 degree
Summary of Contents for Dake VDL-18
Page 38: ...Part VDL 18 38 REV 082020 Parts List Upper Wheel Assembly Parts List Below...
Page 42: ...Part VDL 18 42 REV 082020 Table and Fence Assembly Parts List Below...
Page 46: ...Part VDL 18 46 REV 082020 Upper Lower Blade Guides Assembly Parts List Below...
Page 58: ...Part VDL 18 58 REV 082020 VDL 18 Wiring Diagram...
