Installing without the use of brackets (Technique 3)
1. Remove the original fence system, figure 1.1
Figure 1.1
Figure 1.2
End of ruler must not protrude
past blade slot
Drill and tap for ruler
2.
Drill and tap holes for the ruler indicated in figure 1.2. Note:
hole placement will vary from one machine to another. Drill ½”
holes in bandsaw table for fence studs. Hole location may vary
depending on size of table.
Hole placement from top of table
to center of hole is 38mm. Holes
may need to be elongated.
Match rail studs
to holes
All documentation subject to change without notice
