-10-
www.igm.cz
6.5 Installing/removing the throat plate
1. Unplug the table saw!
2. Insert the throat plate back end first.
3. Lower the throat plate to the table.
4. Lock the throat plate with the thumb-lock.
5. Level the throat plate with the table using
the cat screws.
Note: This machine is shipped with a zero-
clearance throat plate that has already been
cut at the factory. Because of this, there may be
some residue already in the saw.
Installing the throat plate
WARNING: MAKE SURE SAW IS
UNPLUGGED. To remove or install the throat
plate, first set it to the unlock position. Then,
insert the rear end first and tilt the other end
down into position.
Levelling the throat plate
To level the throat plate, adjust the leveling
screws.
Note: Make sure the throat plate is lower than
the cast iron table. Having the throat plate
higher at any position can interfere with the
workpiece feed and cause injury or harm and
increase the chance of kickback
6.6 Installing/removing safety accessories
A: Saw blade
B: Riving knife housing
C: Cam action lever
D: Riving knife
E: Blade guard
F: Blade compliant markings
• Note on the Riving Knife
Since Riving Knife, other than those offered by
Laguna, has not been tested with this product,
use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only
Laguna, recommended accessories should be
used with this product.
•
Note on the saw blade
Installing/removing the riving knife
1. Unplug the tablesaw!
2. Make sure the lock is in open position
3. Insert the blade guard
4. Position the guard insert
5. Lock the blade guard
6. Reinstall throat plate
CAUTION: Make sure the blade guard is in line
with the blade. If it is not in line, please see the
Adjustment section.
3. Insert the blade guard
WARNING: MAKE SURE SAW IS
UNPLUGGED.
With the throat plate removed, and the cam lock
mechanism in the open position (pulled up),
insert the blade guard insert into the slot.
4. Position to the left of the casing
Make sure the guard is positioned correctly and
seated in the bottom of the casing. Grasp the
pawls with one hand, leaving the other hand
free to activate the cam action lock.
5. Lock the blade guard
Keep firm hold of the blade guard with left hand
and engage the cam lock with the thumb of
your right hand.
6. Reinstall the throat plate
Grasp the pawls up and out of the way to re-
insert the throat plate. Lock the throat plate.
CAUTION: Make sure the riving knife is in-line
with the blade. If it is not in line, please see the
Adjustments Section.
6.7 Installing/removing the Blade
1. Unplug the table saw!
2. Remove any blade guards, riving knifes, and
the throat plate to access the blade.
3. Set the disc tilt to 0 degrees.
4. Raise saw to highest position.
5. Engage blade lock (red component).
6. Remove the arbor nut and flange with arbor
wrench.
7. Remove or install blade.
CAUTION: Make sure the teeth of the blade are
facing the front of the saw as shown.
Limit position of the top guard.
This Riving knife with blade guard
only use for 250mm diameter blade.
This Riving knife thickness is 2,3mm
This Riving knife with blade guard
only use for not more than 2mm
blade and 3mm teeth thickness
No saw blade shall be used where
the maximum marked speed is lower
than the selected rotational speed of
the saw spindle.
5500 max rpm
