F1 Table Saw
22
Setup Help Sections
Receiving
It is likely that your machine will be delivered by a third party. Before unboxing, be sure to inspect the
packaging and shipping documents supplied by the driver. Ensure that there is no visible damage to the
shipment. If any damage has occurred because of shipment, note the damage on the bill of lading or refuse
the shipment. Immediately call the dealer store where the machine was purchased.
1. Never accept a shipment that is damaged or partial without notifying the shipping company and the
purchasing store.
Placement
Prior to removing the machine from the packaging, decide the operating location of the machine. The
dimensions and floor space can be found here: Dimensions.
1. There should be sufficient area at the front of the machine to allow you to work on it comfortably.
2. There should be sufficient area at the back of the machine to allow access for adjustments and
maintenance to be conducted.
3. The better the lighting the more accurately and safely you will be able to work.
4. You should select a solid flat floor, preferably one made of concrete or something similar.
5. Locate it close to a power source and dust collection (if applicable).
Unboxing
Once in place, carefully unbox and remove all components. Unboxing guidelines:
1. Do not cut deep into a box with a blade as it could scratch the paint; only cut deep enough to cut the tape
or use a dull edge.
2. Prior to setting up the machine, organize all hardware and setup tools needed.
Summary of Contents for Fusion F1
