22
2. Step mode.
Press the mode button until step is displayed. With step selected, each time
X, or Y button is pressed it will move the router head by 0.5mm in high setting and 0.1mm in
the low setting.
3. Distance mode.
Press the mode button a third time and Distance is displayed. This allows
you to input a position into the controller that you want the router spindle to move to. As an
example, if you want to move the router spindle 100 mm from the home position in the X and /
or Y axis:
1.
Press the mode button until Distance is displayed.
2.
Type in 100 and press OK
3.
Pressing the X+= button will now move the router 100mm in the X+ axis.
The router head also move the set distance in the X+, X-, Y+ and Y- depending on the button
that is pressed.
To move the router head in the Z axis, press the Z+= / 3 [ UP] or the Z- / 7 button [DOWN].
By pressing any of the other X, Y or Z + or
–
buttons the router head will move 100mm in the
selected direction.
Jogging speed
You can select between a Low or High speed. By pressing the HIGH LOW / 0 button you can
toggle between the two speeds. The High speed jog setting is approximately 4 times the
speed of Low speed jog setting.
Summary of Contents for MCNC Swift 60 X 120-0233
