11
Adjustment of Pressure Bar
The pressure bar should be set even with the lowest
point of knife.
1. Disconnect machine from power source.
2. Place a hard wood gauge under a knife in
cutterhead. Raise table until wood gauge
contacts the knife in its lowest position.
3. Place wood block A, Figure 17) under the left
side of pressure bar (B, Figure 17). The top of
wood gauge should just contact the pressure bar.
If it doesn’t, loosen jam nut (C, Figure 18) and
turn the adjusting screw (D, Figure 18) to raise,
or lower the pressure bar until it contacts wood
gauge. Repeat for opposite side of the pressure
bar.
Adjustment of Out-feed Rollers
The out-feed rollers should be set 0.02” below the
lowest point of knife. Make sure the knives are set
properly see the “Setting / Changing Knives” section
on page 11 prior to making any adjustments.
1. Disconnect machine from power source.
2. Place a hard wood gauge (A, Figure 14)
under a knife in the cutterhead. Place a
0.02” feeler gauge (B, Figure 14) on top of
wood block and raise table until the gauge
contacts the knife in its lowest position.
3. Remove feeler gauge and place wood block
(E, Figure 19) under the left side of out-feed
roller (F, Figure 19). The top of wood gauge
should just contact the out-feed roller. If it
doesn’t, loosen jam nut (G, Figure 18) and turn
the adjusting screw (H, Figure 18) to raise,
or lower the out-feed roller until it contacts wood
gauge. Repeat for opposite side of the out-feed
roller.
4. Repeat for second out-feed roller
Summary of Contents for MPLAN25-10-1-0130
