Installation
** Use forklift to move the machine or minimum 4 people to move together.
(1) Control panel
Install control panel with 4 Hex nuts, Lock washer, washer to mount
it to the machine right hand side.
1. Main Switch
：
Power on and power off the panel saw.
2. Emergency stop button disconnects power to motor.
3. Blade " start" button
：
Starts the main saw blade
and scoring saw blade.
4. Blade" stop" button
：
Stops the main saw blade
and scoring saw blade.
2) Crosscut Table
1. Put the crosscut table on the pivot pin of the swing arm. (Fig. 2A)
2. Hold the table (Fig. 2B), insert the T-nut at the back side of the table
align the T-nuts into the sliding T Slot. (Fig. 2C)
3. Make sure table is placed proper in the position tighten the lever. (Fig. 2D)
4. Withdraw lever to move or take off the crosscut table.
Main
switch
Leve
r
Fig.2A
Fig.2B
Fig.2C
Fig.2D
13
Summary of Contents for MPSP12-4-0135
